Page 285 - Pages from 8. 2017 New 26-05-21 No Table- 2nd Half

My main concern at present other than getting the machine to work:] is the error showing 007
error movement of press, as I hope that changing the thermostat will clear error 010, 019 and
then once 009 has been addressed then 011 will no longer exist as a problem if 007 is fixed,
thus repairing the machine.
After speaking to another gentlemen a Morgana it was explained to me that I can attach a
external power supply to the mill and after to the carriage to check the motors to them
mechanism are functioning correctly, on an attempt to do this the mill motor had no issue of
concern and is a straight forward motor to supply the power to, the mill has neutral and live
inclusive of ground. When rerouting the mill I disconnected N1- L1 from Km21.01 within the
fuse board to add the external power supply, with the mill motor activating.
I then attempted to make the press carriage active and took the chain of the motor so the
spindle can move freely, on revealing the wires behind the power plate cover to the motor, for
the power cables to be connected I noticed four wires;
1. One grey in colour: -
2. One brown in colour: -
3. One black in colour: - And: -
4. A green ground wires.
I understood the brown cable to be L1 live and grey to be forward while black would be
reverse to the motor, so I connected the external power supply with the ground connected,
then: -
139,
Same as Above!

39.
Additional Email Attachments & Emails / Issue:
39. 1. 2.
Morgana -1-26355 26-04-2017 09-43
26/04/2017
/ Page Numbers: 140,141
--
140,
From: Rewired <re_wired@ymail.com>
Sent time: 26/04/2017 09:42:42 AM
To: spairs@morgana.co.uk
Subject: In regard to a Pur 150
Dear Mike and Mat
Hello how are you doing, I hope all is well I spoke to a gentleman on the 24/04/2017 on the
phone called mike in regards to a Morgana Pur 150 that I am interested in purchasing from
another person, mike then passed the phone to a man called Mat, who then asked me to send
this reply. The machine I am able to buy seems to come with its own problems and I request
your help in solving the issues.
Diagnostic; when the machine is first turned on it allows any user to go to the first stage
which is; “Are you trained to operate this machine” once ticked in agreement the power to the
machine will flip the main distribution power supply but does not blow the machines internal
fuses.
On a diagnostic of the problem you have to take the two covers of the back of the machine
and bypass the safety mechanism for the hatch door being closed.
Connected to the bottom of the glue station, to which you put the glue into is a thermostat,
this thermostat has two additional wires connected into it.